Home > Windows 2000 > Windows 2000 Shutdown Problems

Windows 2000 Shutdown Problems

The System hive file is located in the %SystemRoot%\System32\Config folder. Flag as duplicate Thanks! What do I do? I list them here as part of the ongoing data collection. navigate to this website

Instead, the start-up sequence may select a drive that is different from the typical drive to start the computer. No Desktop or Blank Desktop After Logging On to Windows 2000 Microsoft Knowledge Base Article: 256194 - When you log on to Windows 2000, you may see a blank desktop or If the system shuts down properly, then one of the devices that you disconnected was causing the problem. After installing, test Windows shutdown.

Navigate to the following computer registry branch: HKEY_CURRENT_USER\Control Panel\Desktop As mentioned above, Windows will hang on for the solutions to closed down and destroy themselves after informing the running solutions to When I completely reinstalled Windows 2000 in April, I thought I had followed the same process used before when a hard drive failed on me. Please check the Windows documentation about hardware disk configuration and your hardware disk configuration and your hardware reference manuals for additional information Error Message: Windows 2000 Could Not Start Because the

One correspondent has confirmed that this matches his experience in trying (unsuccessfully) to use 4.5 on both Widows 2000 and XP. “STOP” ERROR MESSAGES AT SHUTDOWNSome users, when attempting either to Registry Corruption The system Registry is the heart of an NT installation. At this point, you should remove the computer’s case and verify that the hardware listed in the device manager is what’s actually in your system. I used this PC sparingly from October 2005 to April 2006.

Since firstly introduced in Win 95, Safe Mode is available in almost all versions of Windows operating system including Windows 7, Windows Vista, Windows XP, Windows 2000, Windows NT, Windows 98. Please follow sensible Registry editing protocol. Reduce the hang on here we are at customer procedures and applications to be killed As with solutions, Windows will also hang on for a while, depending on WaitToKillAppTimeout setting, before https://www.cnet.com/forums/discussions/windows-2000-won-t-complete-shutdown-169543/ This key controls what your computer does after it receives the "Shutdown" signal.

If you do not use any of these features, then the Terminal Services can be safely disabled. However, the computer may not powerdown correctly after that. Reasons Why Windows NT Does Not Boot From a Shadow Mirror Drive Microsoft Knowledge Base Article: 167045 - Microsoft Windows NT supports Disk Mirroring and Disk Duplexing of the operating system This is not the appropriate shutdown fix for most machines, but does help some users with Windows shutdown problems, and not just with powerdown issues as one might suspect.

Modify the standard value of WaitToKillServiceTimeout of 20000 to lesser value, such as 5000 or even 1000, in close correlation with your preference. Peggy: Great!! As expected, at least half of the Win XP shutdown problems went away with the release of these patches. Monitor Displays a White Screen at Startup and Windows 2000 Stops Responding Microsoft Knowledge Base Article: 305227 - After you start your computer, the monitor may display a blank white screen

Restart the computer. http://internetpasswordpro.com/windows-2000/windows-2000-server-shutdown-hangs.html Yes No Not Helpful 0 Helpful 3 What should I do if my screen is stuck on "shutting down windows" even after several restarts? dBforumsoffers community insight on everything from ASP to Oracle, and get the latest news from Data Center Knowledge. About this wikiHow How helpful is this?

Windows 2000 starts automatically without pausing to display any choices. When the value of WaitToKillServiceTimeout ends, the systems notifies the customer that the service has not stopped, and immediate the customer with option to force the service process to stop or The version P15 is the latest, and I was then and am still running version P05. http://internetpasswordpro.com/windows-2000/windows-2000-shutdown-problem.html If you believe this post is offensive or violates the CNET Forums' Usage policies, you can report it below (this will not automatically remove the post).

In the Control Panel, click User Accounts, then click “Change the way users log on or off.” Uncheck the box that says “Use the Welcome screen.” This removes the initial logon Correspondent Bill Anderson (based on a solution by “Willy”) gave a lengthy description of how to do this (edited a little bit for space reasons): Boot the computer from the Win You can usually tell this by looking at the back of your computer on the power supply.

If you experience this problem, be sure to close all running programs before attempting shutdown and see if this solves your problem.

Exit all programs. 2. Black Screen on Boot Microsoft Knowledge Base Article: 155053 - When you restart a Microsoft Windows NT x86-based computer, the computer stops with an empty, black screen immediately after the power-on Finally, deselect the Automatically Restart check box, shown in Figure A, and click OK. However, the problem occurs whenever you boot into Windows 2000 Windows 2000 Shuts Down When You Try to Restart Your Computer Microsoft Knowledge Base Article: 298925 - When you try to

If not, Windows will hang on for the timeout and start slaying the still running solutions. If you are not a registered user on Windows IT Pro, click Register. Yes No Not Helpful 5 Helpful 8 When I shut down the system, it says, "Some files are open. http://internetpasswordpro.com/windows-2000/windows-2000-won-t-shutdown-restart.html Note that this delay may range from 10 seconds to a minute.

You can decrease the hang on here we are at Windows to murder the persistent solutions. Figure A: The Automatically Restart check box allows Windows to automatically reboot after a failure The technique that I have just shown you will prevent the system from rebooting itself, but Here’s what they have reported: MODEMS: Intel Ambient HaM Modem. Important Links Terms of use Privacy Policy Donation Terms Print Spooler Repair Tool Feedback Email Support Form FeedBack Old3 Contact us Log in Disclaimer techsupportall.com is an independent website.

If the issue is seen lately after creating third-party car owner or applications, experiment with a Program Recover rollback to see if that eliminates the slowly shut down issue. Shut down problems are one of the most common types of problems with the Windows operating system. SOLUTION: Billion has now released a new driver 3.24 that solves this problem, available here. (Tip from Leo Foederer.) MOTHERBOARDS: Asus P2B-F. Without a valid MBR, it's impossible to boot the system from the hard disk.

You should also keep in mind that version 5 is an old version that Roxio no longer supports. Disabling the “restart on system failure” feature may permit the exact cause to be isolated: Right-click on My Computer, click Properties, click the Advanced tab. These included: a damaged exit sound file; incorrectly configured, damaged, or incompatible hardware; conflicting programs, or an incompatible, damaged, or conflicting device driver. Your computer may also restart automatically.

I use ZoneAlarm free firewall, AVG antivirus, Spybot S&D, and Ad-Aware (to the extent possible, all installed before installing service packs or going online to download updates. Under “System Failure,” uncheck the box in front of “System reboot.” Here are some things that have produced this reboot-instead-of-shutdown symptom: By now, the Roxio/Adeptec Easy CD / Direct CD software Startup Problems When Transferring System Hard Disk to a Backup Computer Microsoft Knowledge Base Article: 268066 - A Microsoft Windows NT-based or Microsoft Windows 2000-based server may not start up if Create an account EXPLORE Community DashboardRandom ArticleAbout UsCategoriesRecent Changes HELP US Write an ArticleRequest a New ArticleAnswer a RequestMore Ideas...

This freezes up, or at least significantly delays, Windows shutdown. Upcoming Training Mar 22:Crunching Big Data with Apache Spark with Sasha Goldshtein Mar 22:Data Protection in the Cloud: Lessons Learned from 2016 Mar 23:Infrastructure Challenges with Microsoft SQL Server In-Memory Features Troubleshooting operating system shut down problems is easier than you might think though.