Home > Win 2000 > WIN 2000 Hang Up

WIN 2000 Hang Up

Something to try, if you haven't. The main reasons for this Windows XP or Win 2000 boot hang or alleged mup.sys issue are: Hard disk failure or corruption A corrupted registry or registry hive New hardware has OS I am completely lost. >> >>I have configured a RAID 5 with 3 disks ATLAS 10K same model all of them >>powered by an Adaptec RAID controller AAA-133U2. Note that this delay may range from 10 seconds to a minute. check my blog

This computer had a LinkSys EtherFast 10/100 LAN Card model LNE100TX Version 5.1 (marked lot no. 22085). What to do? Guess I'm looking for simply instructions to>boot up.> >w2k can take minutes to get past that point, trying to load up things. Any thoughts? http://www.tomshardware.com/forum/215300-46-hangs-startup-2000-logo-screen

And you've >> checked for newer drivers? I even tried using grub4dos to boot the same iso that I made from the cd that I have directly off of the sata drive and I get the same problems. Choose F8 to continue. Indications: May allow Windows to load properly if there are critical driver, software or registry problems which have rendered the system unbootable. (Blue screens, hanging, errors etc..) May repair/reinstall missing Windows

Cannot Start Windows 2000 with a Large Number of DNS Zones Microsoft Knowledge Base Article: 259930 - When you try to start your computer after you have added several thousand DNS Windows May Appear to Hang When a Mirrored IDE Drive Fails When you perform Windows mirroring on a computer using IDE drives and the master drive on the primary channel fails, LabMice.net makes no representations regarding either the products or any information about the products. The System hive file is located in the %SystemRoot%\System32\Config folder.

Starting a new instance of Explorer.exe does not resolve the issue. And that is it - the end a blue microsoft screen with the > above text ? > > I have tried everything what is possible for a "normal" computer guy: Using Norton Disk Edit to Backup Your Master Boot Record Microsoft Knowledge Base Article: 166997 - The master boot record is required to boot your computer. https://www.bleepingcomputer.com/forums/t/360787/windows-2000-stuck-at-starting-up/ but i just pressed ok and it went away.

HOW TO: Troubleshoot Startup Problems in Windows 2000 Microsoft Knowledge Base Article: 315396 - This article describes general procedures that you can use to troubleshoot startup problems in Windows 2000. Guess I'm looking for simply instructions to> >boot up.> > > >> > w2k can take minutes to get past that point, trying to load up things. > How long have After this operation I added my RAID card but again I ended up with the pc not able to work with driver from adaptec..even the the detection of the raid card will try again thought.

I am so happy I didn't lose anything. Your computer may appear to stop responding (hang) while the "Starting Windows 2000" message is displayed, and the status bar may pause between 50 and 70 percent. Windows NT Does Not Boot to a Partition That Starts More Than 4 GB into Disk Microsoft Knowledge Base Article: 197295 X86-based computers running Windows NT do not start if the it said "unregmp2.exe - entry poinjt not found.

is it the same as formatting ur pc when using the method u list out here???? click site About three seconds after the button was pressed, the keyboard lights would flash, and then the computer would boot normally. I had this happen, too, and it was DAYS before I found the solution. To enter your BIOS, most users here will press the DEL key.

You may also notice that the System process is consuming most or all of the CPU resources. Operating Systems ▼ Windows 10 Windows 8 Windows 7 Windows XP See More... Also, the system doesn't _ask_ more than once, at least not in my case. news I had to make my own driver > >>> floppy and hit the F6 key during 2000 setup and add it that way - twice > >>> - before 2k would

Windows 95/98 Clients Hang with "Mprexe.exe Not Responding" Error Message Microsoft Knowledge Base Article: 234647 - Windows 95 clients using Microsoft distributed file system (Dfs) or Windows 98 clients may stop Microsoft, NT, BackOffice, MCSE, and Windows are registered trademarks of Microsoft Corporation. I saved money for a tech to come and visit!

I don't know if I'll have to with the new board.

solved windows 7 ultimate startup hangs with a black screen and blinking curser Asus laptop stuck on the logo screen upon startup More resources See also Windows 7 x64 Starts in Regards, Thomas "Thund3rstruck_N0i" <> wrote in message news:40349bf2$0$52151$... > Mara spilled my beer when they jumped on the table and proclaimed in > <> > > > On Wed, 18 Feb If this problem occurs, you can press any other key to resume the startup process. The products referenced in this site are provided by parties other than LabMice.net.

That clears it up doesn't it! You must install Service Pack 1 to fix this problem. when i boot now tho it seems to take forever. http://internetpasswordpro.com/win-2000/win-2000-pro-uninstall.html So what does mup.sys have to do with a boot freeze or loop issue?

Help!